Differences

This shows you the differences between two versions of the page.

--- en:appnote:an016 [2015/03/06 14:39] – creata qem103
+++ en:appnote:an016 [2019/08/29 17:01] (current) – external edit 127.0.0.1
@@ Line 1: / Line 1: @@
+====== AN016 - Battery replacement procedure ======
+Before replacing the battery we recommend that you verify that the battery is new:
+  * charge (use the tester);
+  * compatibility.
+For greater security and data protection, make a copy of the data in RAM with the Project procedure > Backup or with the Project procedure > Savedata with the Qview software.
+__**The battery replacement must be provided with the equipment turned on.**__
+Replacement descriptions:
+|Fig.1 Remove the battery cover\\ with flat screwdriver\\ to pry the tabs|
+|{{:strumenti:qmove:an016:1.png?nolink&250}}|
+|Fig.2 Replace the battery make sure of\\ respect the polarity|
+|{{:strumenti:qmove:an016:2.png?nolink&250}}|
+|Fig.3 Put back the cover battery|
+|{{:strumenti:qmove:an016:3.png?nolink&250}}|
+|Fig.4 Turn off and than turn on the instrument|
+|{{:strumenti:qmove:an016:4.png?nolink&250}}|
+|Fig.5 If the procedure is correct\\ BATT led stay OFF [(Only for CPU D and E. For CPU B and C, the BATT led can be reset with the Reset allarm battery.)]|
+|{{:strumenti:qmove:an016:1.png?nolink&250}}|
+~~REFNOTES~~
+If after replacing the battery the BATT stays on or flashes you should contact the constructor of the machine.\\
+If the BATT led turn OFF, but the ERR led flash for Error Checksum, you should restore the data save with the Project procedure > Restore or Project > Recalldata from Qview.\\
+If you ran a Project > Backup is possible to run the Restore even without the PC.\\
+If after the installation or battery replacement, HALT led flash, set the data, the time and reset the “Internal Error".\\
+(Note: if the command does not work, turn off the instrument, turn on the instrument and repeat the procedure)