Differences

This shows you the differences between two versions of the page.

--- en:lib:mdl:mdl-a-tarisass-011 [2015/02/11 15:25] – [1. Maximum Belt Speed calibration] qem102
+++ en:lib:mdl:mdl-a-tarisass-011 [2019/08/29 17:01] (current) – external edit 127.0.0.1
@@ Line 1: / Line 1: @@
+==== Axis Resolution ====
+{{:strumenti:qmoveplus:j1p20:mdu_p1p20fh20-001:buttons:button_180x90_resol_002.png?nolink&50}} -> {{lib:mdl:mdl-a-tarisass:tar_ris_asse_02.png?nolink&250}}
+=== Procedure ===
+{{:lib:mdl:mdl-a-tarisass:tar_ris_asse_01.png?nolink&400}}
+  * Press {{:tasti_touch:piu.png?nolink&30}} and check the ENCODER box increases(Analog out +1 Volt)
+  * Press {{:tasti_touch:meno.png?nolink&30}} and check the ENCODER box decreases (Analog out -1 Volt)
+  * A - A' = The maximum space
+  * Take note of the start position (A)
+  * Zero-set the **ENCODER**: {{:tasti_touch:eq_zero.png?nolink&30}}
+  * Move the axis from A to A'
+  * Take note of the reading in **ENCODER** box and write it in the **PULSE** box
+  * Measure the distance from A to A' = **space delta**
+  * Enter the A - A' **space delta** in the **MEASURE** box
+**Important:**
+  * **PULSE** must alway be greater than **MEASURE** (the best is "MEASURE x 10 = PULSE")
+  * Enter **MEASURE** in the selected **unit measure**. E.G. if a unit measure of 1/10mm is selected and the **space delta** is 133.5mm, enter 1335 in the **MEASURE** box