List of System Functions
All the system functions are listed below.
Controllers without display do not require the system password, so the “PWD” column is empty.
System Functions
| n. | Led ON | System Function | PWD | Description |
|---|---|---|---|---|
| 1 |  L1 | 01 - Reset Error Checksum | - | Reset errore checksum. N.B.: if the checksum error is present, the led L1 flashes. |
| 2 | L2 | 02 - Copy all files MMC/SD → NAND | - | Not used for this hardware |
| 3 | L1 L2 | 03 - Copy all files NAND → MMC/SD | - | Not used for this hardware |
| 4 | L3 | 04 - Application delete | - | Dele the application. |
| 5 | L1 L3 | 05 - Application upload from MMC/SD | - | Upload the application from MMC/SD. |
| 6 | L2 L3 | 06 - Set Date & Time | - | Not used for this hardware |
| 7 | L1 L2 L3 | 07 - Downl. retentive data to MMC/SD | - | Save the retentive data on MMC/SD. |
| 8 | L4 | 08 - Set NEW Password | - | Not used for this hardware |
| 9 | L1 L4 | 09 - Remove all files from NAND Flash | - | Not used for this hardware |
| 10 | L2 L4 | 10 - Show NAND Flash files | - | Non implementata per questo hardware |
| 11 | L1 L2 L4 | 11 - Touch Calibration | - | Not used for this hardware |
| 12 | L3 L4 | 12 - Set Ethernet communic. parameter | - | Run the setup procedure for the Ethernet communication parameters (IP address,…, etc.) |
| 13 | L1 L3 L4 | 13 - Backup to NAND | - | Run the backup of the QCL application, data and HMI application on NAND memory. |
| 14 | L2 L3 L4 | 14 - Restore from NAND | - | Run the restore of the QCL application, data and HMI application from NAND memory. |
NB: To exit system functions press the keep the F1 key or FUNC button for at least two seconds.