Differences

This shows you the differences between two versions of the page.

--- en:lib:mdl:mdl-f-scautodiagn-010 [2015/11/04 13:35] – created qem207
+++ en:lib:mdl:mdl-f-scautodiagn-010 [2019/08/29 17:01] (current) – external edit 127.0.0.1
@@ Line 1: / Line 1: @@
+==== SELF-DIAGNOSIS state ====
+During the startup, after scanning the system led's, the controller performs a series of self-diagnostic operations. When any faults are detected or the operator has to be informed of any given situation, the self-doagnosis procedure is temporarily interrupted, signalling the event.\\
+The fault signal is made by led's L1, L2 and a message is given on display (if present).
+== System Messages ==
+^n.^Led ON^System Message (if display present)^Description^Type^
+|**1**|{{led:led_on.jpg?nolink&20}} L1|''System Data WRITE ERROR''|Indicates that a write error has occurred during the configuration data saving.|  **B**  |
+|**2**|{{led:led_on.jpg?nolink&20}} L2|''System Data IS RESTORED FROM DEFAULT''|Indicates that the configuration data has been restores to the default settings.|  **C**  |
+|**3**|{{led:led_on.jpg?nolink&20}} L1\\ {{led:led_on.jpg?nolink&20}} L2|''System Data is updated''\\ Please verify new data|Indicates that the configuration data has been converted into a new format. Check that the previous settings have been maintained.|  **C**  |
+|**4**|{{led:led_on.jpg?nolink&20}} L3|''Firmware is updated\\ old: 1K31F10 1.001\\ new: 1K31F10 1.002''|Indicates that a firmware update has been made.|  **C**  |
+When the condition detected allows to continue to the start stage (type **C**) and waits for the **FUNC ** button {{varie:pulsante_3x6_01.png?nolink&20}} or for the **F1** key {{tasti:tasto_f1.png?nolink&30}} to be pressed to continue the boot procedure.
+If not provided with a display, the controller waits **5 seconds** before continuing with the startup stage, without waiting for a button to be pressed.
+When the situation does not allow to continue the startup stage (tipo **B**), the controller, if provided with a display, shows the message''"PLEASE TURN OFF AND TURN ON THE SYSTEM"'' and remains in this state until you turn off. If the controller is not provided with a display, the led {{led:led_lamp.jpg?nolink&20}} **err** flashes continuously.