en:lib:mdl:mdl-h-ecqmplus-010

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
en:lib:mdl:mdl-h-ecqmplus-010 [2016/09/14 17:14] – [CANbus] qem103en:lib:mdl:mdl-h-ecqmplus-010 [2019/08/29 17:01] (current) – external edit 127.0.0.1
Line 1: Line 1:
 +
 +====== - Connection examples ======
 +=====CANbus=====
 +{{schemi:cbl_canbus_01.png?nolink&450|Esempio di collegamento dei moduli remotati al controllore}}
  
 +^:important:^ • On the first (1) and on the last (3) device of the chain, the termination resistances must be inserted.\\ • The cable shoes must be connected to ground by the fastons provided on the metal body.^
 +
 +^:info:^ • To activate the internal termination resistance see paragraph  [[#Setup of CAN1 and CAN2 PORT Termination resistances]]^
 +
 +<html><pagebreak /></html>
 +
 +=====Digital inputs=====
 +{{schemi:cbl_in-standard_01.png?nolink&450|Esempio di collegamento di ingressi standard, più ingresso veloce PNP}}
 +
 +<html><pagebreak /></html>
 +
 +/*
 +=====Line Driver count inputs=====
 +{{schemi:cbl_conteggio-ld_01.png?nolink&400|Connection example of a Line Driver count input}}
 +
 +<html><pagebreak /></html>
 +*/
 +=====PNP / Push Pull count inputs=====
 +{{schemi:cbl_conteggio-pp-pnp_01.png?nolink&400|Connection example of a PNP/Push Pull count input}}
 +
 +<html><pagebreak /></html>
 +
 +=====Voltmetric and amperometric analog inputs=====
 +{{schemi:cbl_in-volt-amp_01.png?nolink&400|Connection example of amperometric and voltmetric analog inputs}}
 +
 +<html><pagebreak /></html>
 +
 +=====Voltmetric and potentiometric analog inputs=====
 +{{schemi:cbl_in-volt-pot_01.png?nolink&400|Connection example of potentiometric and voltmetric analog inputs}}
 +
 +<html><pagebreak /></html>
 +
 +=====Protected digital outputs=====
 +{{schemi:cbl_out-protette_01.png?nolink&400|Connection example of protected outputs}}
 +
 +<html><pagebreak /></html>
 +
 +/*
 +=====STEP - DIRECTION outputs=====
 +{{schemi:cbl_stepper_pp-ld_01.png?nolink&450|Connection example of stepper motor command outputs}}
 +
 +<html><pagebreak /></html>
 +*/
 +=====Analog outputs=====
 +{{schemi:cbl_out-analogic_01.png?nolink&400|Connection example of analog outputs}}