Differences
This shows you the differences between two versions of the page.
| en:lib:mdl:mdl-h-qsgcheck-010 [2016/07/28 15:26] – created qem103 | en:lib:mdl:mdl-h-qsgcheck-010 [2019/08/29 17:01] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | /*====== -Correct operation checks ======*/ | ||
| + | After you have correctly connected the instrument to the power line, as mentioned above, you can proceed with the power up. | ||
| + | |||
| + | ===== Power up ===== | ||
| + | |||
| + | In the powering up, the Leds are scanned: | ||
| + | |||
| + | the 8 LED light up sequentially on the rear of the instrument (pow, run, stop, err, L1, L2, L3 and L4). | ||
| + | |||
| + | {{ : | ||
| + | |||
| + | ===== Self-diagnostics ===== | ||
| + | |||
| + | After scanning of the leds, the device performs a series of diagnostic operations. | ||
| + | |||
| + | When the anomalies are detected or when is need to notify at the operator a particular situation, the autodiagnosis operation is momentarily interrupted, | ||
| + | |||
| + | Any malfunction is stand out from the **L1**, **L2** leds and a display message. | ||
| + | |||
| + | If the device is working properly, at the end of the stages of switching on self-diagnostics, | ||
| + | |||
| + | *led **pow **in ON (CPU in RESET state) | ||
| + | *led **pow** and **run** in ON (CPU in RUN state) | ||
| + | *led **pow** in ON and the **run** in flashing(CPU in READY state) | ||