After you have correctly connected the instrument to the power line, as mentioned above, you can proceed with the power up.
In the powering up, the Leds are scanned:
the 8 LED light up sequentially on the rear of the instrument (pow, run, stop, err, L1, L2, L3 and L4).
After scanning of the leds, the device performs a series of diagnostic operations.
When the anomalies are detected or when is need to notify at the operator a particular situation, the autodiagnosis operation is momentarily interrupted, and the device pointing out the alarm.
Any malfunction is stand out from the L1, L2 leds and a display message.
If the device is working properly, at the end of the stages of switching on self-diagnostics, you may encounter the following situations: