| SW1 | Dip | DIP settings | Function | |||
|---|---|---|---|---|---|---|
 | 1 | OFF | Baud-rate 57600 | Select PROG PORT transmission speed | ||
| ON | Baud-rate 115200 | |||||
| 2 | OFF | Baud-rate 57600 | Select USER PORT transmission speed | |||
| ON | Baud-rate 115200 | |||||
| 3 | OFF | Can also be used by SERCOM and MODBUS devices | Select PROG PORT functioning mode | |||
| ON | Cannot be used by SERCOM and MODBUS devices | |||||
| 4 | OFF | ON | OFF | ON | CANbus baud-rate selector (CanOpen)1) | |
| 5 | OFF | OFF | ON | ON | ||
| Baud-rate 125KB/S | Baud-rate 250KB/S | Baud-rate 500KB/S | Baud-rate 1MB/S |
|||
| 6 | OFF | IQ009 connection | Mini USB 5Vdc supply2) | |||
| ON | IQ021 connection | |||||
| 7 | Not used | |||||
| 8 | OFF | PROG PORT normal | Select the USER PORT as PROG PORT3) | |||
| ON | PROG PORT on USER PORT connector | |||||
1)
Valid if the declaration of the CANopen device is set the speed to 0
2)
If enabled, on the mini USB connector of the PROG POR, 5Vdc are available for the IQ021 Bluetooth Interface power supply.
3)
It is possible to use the USER PORT connector as PROG PORT with RS232 electric standard, doing this the mini-USB connector of the PROG PORT is disconnected (Setting USER PORT electric standard). For this function mode also set dip 6 of SW2 to OFF.