This shows you the differences between two versions of the page.
| |
| en:lib:tpl:tpl-s-ipfirerr-010 [2015/10/20 11:45] – created qem207 | en:lib:tpl:tpl-s-ipfirerr-010 [2019/08/29 17:01] (current) – external edit 127.0.0.1 |
|---|
| | When downloading the Qmove application, the QView-6 development environment can give error messages that are not described in the development environment manual. These errors are special and the description string given by QView-6 is generated directly by the firmware. |
| |
| | The table below describes possible error messages generated by the firmware. |
| | |
| | == Firmware error messages== |
| | ^Possible error message^Description^ |
| | |''Error: SYSTEM + ARRSYS + DATAGROUP + INTDEVICE size overflow by 234bytes.''|Given when the retentive variables exceed the maximum limit.| |
| | |''Error: serial port not avaliable in SERCOM or MODBUS device declaration.''|Given when the wrong number is used during the device declaration to select the communication channel.| |
| | |''Error: CANOPEN device required if you use more than 3 slots.''|In the BUS definition more than 3 slots are being used and so the application requests the use of Canopen modules. To manage this, a CANOPEN device must be declared.| |
| | |''Error: incorrect bus fault mode in CANOPEN declaration.''|The CANOPEN device declaration indicates a fault mode (last value in the declaration) that is not supported.| |
| | |''Error: incorrect canbus speed in CANOPEN declaration.''|The CANOPEN device declaration indicates an invalid speed.| |
| | |''Error: too much CANOPEN device declaration.''|Only one CANOPEN device can be declared.| |
| | |''Error: absol. encoder resource num in ABSCNT device declar. is not avail.''|The ABSCNT device declaration indicates an inexistent resource.| |
| | |''Error: COUNT in ABSCNT device declaration is not a simulated counter.''|The counter address used in the ABSCNT device declaration cannot be a simulated type (e.g. 1.CNT01).| |
| | |''QMos version error. Unsupported instructions set.''|One or more statements in the project QCL are not supported by the firmware.| |
| | |''Error: compression file type not support.''|The compression of the compiled QCL program is not supported by the firmware.| |
| | |''Error: too mutch slots in bus declarations.''|They were declared under BUS more slots than those allowed by the hardware.| |