Differences

This shows you the differences between two versions of the page.

--- en:strumenti:qmoveplus:j1p44:p1p44f-010:mdi_p1p44f-010 [2021/04/21 18:25] – [4.1 General Setup] qem103
+++ en:strumenti:qmoveplus:j1p44:p1p44f-010:mdi_p1p44f-010 [2021/04/22 12:45] (current) – [6.4 Hydraulic brake operation (wedges) W and H axes] qem103
@@ Line 682: / Line 682: @@
 <html><pagebreak /></html>
+===== - Hydraulic brake operation (wedges) W and H axes =====
+Active function with parameter //PG-34// = 1. Operating sequence:
+  - Before handling the W or H axes, the **O63** output of the hydraulic control unit is activated
+  - The Hydraulic brakes (wedges) are portrayed from the resting position (normally pushed by a spring in the axle locking seat)
+  - When wedges are fully portrayed, they activate the input **I70**
+  - The W or H axes move
+{{:strumenti:qmoveplus:j1p44:p1p44f-010:wh_brake.png?400}}
 ===== - Backlash recovery =====