Differenze
Queste sono le differenze tra la revisione selezionata e la versione attuale della pagina.
Entrambe le parti precedenti la revisione Revisione precedente Prossima revisione | Revisione precedente Prossima revisioneEntrambe le parti successive la revisione | ||
lib:mdl:mdl-s-ipvarsis-010 [2015/10/16 11:00] – qem207 | lib:mdl:mdl-s-ipvarsis-010 [2016/09/12 16:57] – [sys004] qem103 | ||
---|---|---|---|
Linea 1: | Linea 1: | ||
- | ==== Variabili di sistema | + | ==== - System Variables |
- | L' | + | |
- | Lo scopo del presente paragrafo è illustrare le 16 variabili di sistema chiamate sys001÷sys016 il cui significato dipende dal firmware che si sta utilizzando. | + | |
- | == sys001 == | + | The development environment provides |
- | Questa variabile | + | |
- | 0 = nessun pulsante premuto.\\ | + | |
- | 1 = pulsante FUNC premuto.\\ | + | |
- | 2 = pulsante BOOT premuto.\\ | + | |
- | 3 = pulsanti FUNC e BOOT premuti. | + | |
- | == sys002 | + | == - sys001 |
- | Questa variabile permette la lettura dell' | + | |
- | NB: Alcuni dip non sono collegati al microprocessore e quindi viene letto sempre al livello logico | + | This is a read only variable that indicates the status of the FUNC (bit 0) and BOOT (bit 1) buttons. The following settings are possible:\\ |
+ | 0 = no button pressed.\\ | ||
+ | 1 = FUNC button pressed.\\ | ||
+ | 2 = BOOT button pressed.\\ | ||
+ | 3 = FUNC and BOOT buttons pressed. | ||
- | == sys003 | + | == - sys002 |
- | Questa variabile permette il comando del led L1-L2-L3-L4. Il bit 0 corrisponde a L1, il bit1 a L2 e così via. | + | |
- | == sys004 | + | This variabile allows to read a dump of the SW1 dip-switches. The dump is acquired only after the controller is powered. The Bit 0 corresponds to dip 1 and so on. |
- | Questa variabile permette l'impostazione del filtro | + | |
- | Il valore impostato di default | + | NOTE: Some dips are not connected to the microprocessor and is therefore always read at logic level 0. |
+ | == - sys003 | ||
+ | |||
+ | This variable allows the command of led's L1-L2-L3-L4. The bit 0 corresponds to L1, the bit1 to L2 and so on. | ||
+ | |||
+ | == - sys004 == | ||
+ | |||
+ | This variable allows toxet the anti-glitch | ||
== sys005÷16 == | == sys005÷16 == | ||
Non utilizzata. | Non utilizzata. |