Differenze
Queste sono le differenze tra la revisione selezionata e la versione attuale della pagina.
Entrambe le parti precedenti la revisione Revisione precedente Prossima revisione | Revisione precedente Prossima revisioneEntrambe le parti successive la revisione | ||
lib:mdl:mdl-s-ipvarsis-010 [2016/09/12 16:54] – [sys001] qem103 | lib:mdl:mdl-s-ipvarsis-010 [2016/09/12 16:56] – [sys003] qem103 | ||
---|---|---|---|
Linea 3: | Linea 3: | ||
The development environment provides a series of ready-made variables that can be used by putting the word “QMOVE.” before the name. For example “QMOVE.is_suspend”, | The development environment provides a series of ready-made variables that can be used by putting the word “QMOVE.” before the name. For example “QMOVE.is_suspend”, | ||
- | == sys001 == | + | == - sys001 == |
This is a read only variable that indicates the status of the FUNC (bit 0) and BOOT (bit 1) buttons. The following settings are possible:\\ | This is a read only variable that indicates the status of the FUNC (bit 0) and BOOT (bit 1) buttons. The following settings are possible:\\ | ||
Linea 11: | Linea 11: | ||
3 = FUNC and BOOT buttons pressed. | 3 = FUNC and BOOT buttons pressed. | ||
- | == sys002 == | + | == - sys002 == |
- | Questa variabile permette la lettura dell' | + | |
- | NB: Alcuni | + | This variabile allows to read a dump of the SW1 dip-switches. The dump is acquired only after the controller is powered. The Bit 0 corresponds to dip 1 and so on. |
- | == sys003 == | + | NOTE: Some dips are not connected to the microprocessor and is therefore always read at logic level 0. |
- | Questa variabile permette il comando del led L1-L2-L3-L4. | + | == - sys003 == |
+ | |||
+ | This variable allows the command of led' | ||
== sys004 == | == sys004 == |