Have been moved two existing parameters and included two new parameters in the setup page generic.
Parameters name | Unit of measure | Default | Range | Description |
---|---|---|---|---|
DxRot distance | mm | 0.0 | -9999.9 ÷ 99999.9 | The X distance between the rotation axis C and the axis of rotation of the spindle when the axis C is located at 0 ° and the axis A is located at 90°. |
DyRot distance | mm | 20.0 | -9999.9 ÷ 99999.9 | The Y distance between the rotation axis C and the vertical axis of the blade when the axis C is located at 0 ° and the axis A is located at 90° (see the next image). |
DzRot distance | mm | 171.0 | -9999.9 ÷ 99999.9 | The Z distance between the tilt axis A and the axis of rotation of the spindle (see the next image). |
DyAC distance | mm | 119.0 | -9999.9 ÷ 99999.9 | The distance between the C axis and the A axis (see the next image). |
There is a new setup page for the A axis:
Parameters name | Unit of measure | Default | Range | Description |
---|---|---|---|---|
Resolution | - | 1/1 | - | The resolution parameters to convert pulse to degrees: measure in °/10 over pulse. |
Tolerance | ° | 0 | 0.0 ÷ 99999.9 | The tolerance to check if the tilt position of A is to the right displacement. |
Min A angle | rad | 0 | 0.0 ÷ 9.99999 | It is the minimun angle for axis A. If the A position is less than this angle, the cut will not be done. |
There is a new feature allow on each manual page.
When you touch on the next button, it will toggle on one of the next picture. The meaning is the next:
![]() | By the Z joystick activation, the machine move only the Z axis. So it will be a vertical displacement. |
![]() | By the Z joystick activation, the machine move the three XYZ axis in according of the A and C positions. So it will be a cut direction displacement. |
There is a new work allow from the execution menu page. It is “Rectangle”:
There are the next work parameters:
Parameters name/picture | Unit of measure | Range | Description |
---|---|---|---|
![]() | mm | 0 ÷ 99999.9 | W and H are the rectangle dimensions. These are the dimensions on the upper surface of the slab. The software processes the cut position in according to the saw thickness and tilting. |
![]() | - | - | For each edge of the rectangle you have to set the angle orientation. Touch on the icon, press the ![]() ![]() |
![]() |
|||
A | ° | 10.0 ÷ 90.0 | The operator has to insert the tilting angle for each edges, even for vertical cut (90°). |
![]() | - | - | The operator can enable or disable each edges of the rectangle. He has to just touch the |
![]() |
|||
![]() | mm | 0 ÷ 99999.9 | The operator has to insert the slab thickness. |
![]() | mm | -99999.9 ÷ 99999.9 | It is possible to apply a correction of the start quote of the cut. |
![]() | mm | -99999.9 ÷ 99999.9 | It is possible to apply a correction of the end quote of the cut. |