Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revisionBoth sides next revision | ||
en:software:devices:modbus [2016/12/21 15:05] – [5.2. Modo di funzionamento MASTER] qem103 | en:software:devices:modbus [2016/12/21 15:13] – [5.2.1. Parametri per formattare il messaggio:] qem103 | ||
---|---|---|---|
Line 151: | Line 151: | ||
Using the two commands SEND or SENDSYC you send the read or write request to the slave, a number of States allow an audit on the operation being executed. We see in detail: | Using the two commands SEND or SENDSYC you send the read or write request to the slave, a number of States allow an audit on the operation being executed. We see in detail: | ||
- | === - Parametri per formattare il messaggio: === | + | === - Parameters for formatting the message: === |
- | **type** = tipo di richiesta che si vuole processare | + | |
- | **idcard** = indirizzo dell’unità | + | **type** = request type that you want to process |
- | **addr** = indice da cui iniziare a leggere o da cui iniziare a scrivere nello slave in questione.\\ | + | **idcard** = address of the slave drive to which you want to send the request.\\ |
- | **tabreg** = per le operazioni di lettura | + | **addr** = the index from which to start reading or at which to start writing |
- | **num** = numero di valori che si intendono leggere o scrivere | + | **tabreg** = for read operations |
+ | **num** = number of values that are read or write (if the request | ||
=== - Comandi per inviare il messaggio: === | === - Comandi per inviare il messaggio: === |