Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
en:software:devices:modbus [2016/12/21 16:56] – [5.2.3. Variabili di Stato per diagnostica operazione:] qem103 | en:software:devices:modbus [2016/12/21 17:39] – [Read Holding Register] qem103 | ||
---|---|---|---|
Line 169: | Line 169: | ||
The SENDSYC coomand it becomes necessary when you want to synchronize master data packet writing by reading the same data from the slave (can be used when both master and slave are Qmove). | The SENDSYC coomand it becomes necessary when you want to synchronize master data packet writing by reading the same data from the slave (can be used when both master and slave are Qmove). | ||
- | ==== - Richieste di lettura | + | ==== - Read request |
=== Read Coil === | === Read Coil === | ||
- | Funzione di lettura | + | |
- | impostare | + | Bit read function. You want to read the bits of a slave (// |
- | numero di bit che si intendono leggere. Bisogna impostare | + | (//addr// + //num// - 1) <= 512 e (//tabreg// + //num// - 1) <= 512 otherwise the request will fail (reporting by //wcmd//). |
- | master | + | |
- | soddisfare sempre le seguenti due condizioni:\\ | + | |
- | (//addr// + //num// - 1) <= 512 e (//tabreg// + //num// - 1) <= 512 altrimenti la richiesta non potrà essere eseguita | + | |
=== Read Input === | === Read Input === | ||
- | Funzione di lettura a bit. Si vogliono leggere i bit di un certo slave (// | + | |
+ | Bit read function. To read the bits of a slave (// | ||
=== Read Holding Register === | === Read Holding Register === | ||
- | Funzione di lettura a word. Si vogliono leggere le word di un certo slave (idcard). | + | |
- | Bisogna impostare | + | Word read function. Si vogliono leggere le word di un certo slave (idcard). |
- | indica il numero di word che si intendono leggere. Bisogna impostare | + | You must to set addr to indicate the address of the word in the slave from which to start reading. The num parameter indicates the number of word to be read. You must set tabreg |
- | dei dai letti” del master | + | (addr + num - 1) <= 32 e (tabreg + num - 1) <= 32 otherwise the request will fail (reporting by wcmd). |
- | Si raccomanda di soddisfare sempre le seguenti due condizioni:\\ | + | |
- | (addr + num - 1) <= 32 e (tabreg + num - 1) <= 32 altrimenti la richiesta non potrà essere eseguita | + | |
- | wcmd). | + | |
=== Read Input Register === | === Read Input Register === |