Differences

This shows you the differences between two versions of the page.

--- en:software:devices:modbus [2016/12/21 17:45] – [Read Holding Register] qem103
+++ en:software:devices:modbus [2016/12/21 17:50] – [Force coil] qem103
@@ Line 190: / Line 190: @@
 Word read function. For reading the bit of the slave (idcard). The function is equal to the “Read Holding Register”. sets the parameter type = 4.\\ The meaning of the two functions is distinguished at the level of MODBUS protocol. Some slave can make available different memory areas depending if the read word are Holding or Input. In the case of slave Qmove the two requests have the same effect.
-==== - Richieste di scrittura ====
+==== - Write request ====
 === Force coil ===
-Funzione di scrittura bit. Si vogliono scrivere (forzare) i bit di un certo slave (//idcard//). Viene impostato il parametro //type// =
-.\\ Bisogna impostare addr per indicare l’indirizzo del bit nello slave in cui si intende scrivere. Bisogna impostare tabreg
+Bit write function. For writing (force) the bit of the slave (//idcard//). Sets the parameter //type// = 5.\\ You must set addr to indicate the address of the bit in the slave that you want to write. You must set tabreg to indicate the index of the bit in the “write data table” that contains the value to be written.
-per indicare l’indice del bit nella “tabella dei dati da scrivere” in cui è contenuto il valore da scrivere.
 === Force register ===