Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
en:software:devices:modbus [2016/12/22 16:07] – [5.8. Identificazione degli Slave] qem103 | en:software:devices:modbus [2016/12/23 14:53] – [5.10.1. Simbologia adottata] qem103 | ||
---|---|---|---|
Line 310: | Line 310: | ||
ENDIF | ENDIF | ||
</ | </ | ||
- | ==== - Estensione del protocollo | + | ==== - Protocol extension |
- | Il protocollo di comunicazione | + | The modbus standard |
* INPUT STATUS, | * INPUT STATUS, | ||
* COIL STATUS, | * COIL STATUS, | ||
* INPUT REGISTER, | * INPUT REGISTER, | ||
* HOLDING REGISTER. | * HOLDING REGISTER. | ||
- | Questi | + | These 4 types treat signals as Digital Inputs, Digital Outputs, Analog Inputs, and Analog Outputs. |
- | (sia INPUT REGISTERS | + | To allow support for datatypes larger than 16 bit, has been designed an extension to the protocol to treat long 32 bit dimension values. Implementing this feature preserves the formatting of the message |
- | (esempio | + | |
- | Per permettere di suppportare tipi di dato di dimensione maggiore di 16 bit, è stata progettata una estensione al protocollo | + | |
- | per trattare valori di dimensione | + | |
- | messaggio | + | |
- | questa estensione è attiva | + | |
- | per ogni richiesta di registro. Se l’indirizzo è superiore a 5000 verrà risposto con valore | + | |
- | rimane invariato con risposta a 16 bit. | + | |
- | ==== - Comandi e parametri | + | ==== - Commands and parameters |
- | === - Simbologia adottata | + | === - Used symbols |
- | Il nome del parametro, stato o comando viene riportato alla sinistra della tabella. | + | |
+ | The parameter name, condition or command is taken back to the left side of the table. | ||
**R**\\ | **R**\\ | ||
- | Indica se il relativo parametro o stato è ritentivo | + | Indicates if the parameter or state is retentive |
- | Se il device | + | If the device |
- | R = Ritentivo\\ | + | R = Retentive\\ |
- | 0 = Al momento dell’inizializzazione del device | + | 0 = Upon initialization of the device |
- | 1 = Al momento dell’inizializzazione del device | + | 1 = Upon initialization of the device |
- | - = Al momento dell’inizializzazione del device | + | - = Upon initialization of the device |
**D**\\ | **D**\\ | ||
- | Indica la dimensione del parametro.\\ | + | Indicates the size of the parameter.\\ |
F = Flag\\ | F = Flag\\ | ||
B = Byte\\ | B = Byte\\ |