This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revisionBoth sides next revision |
| en:software:devices:modbus [2016/12/27 14:34] – [6.3.3. Variabili] qem103 | en:software:devices:modbus [2016/12/27 14:40] – [6.3.4. Stati] qem103 |
|---|
| |serr|B|0|R/W|-|**Serial Errors**\\ Indicates if errors occurred in serial communication.\\ The parameter is updated for each error encountered. The value persists until a subsequent error or to a writing on the same with the QCL.\\ **0** = no errors,\\ **1** = parity error,\\ **2** = framing error,\\ **3** = overrun error.| | |serr|B|0|R/W|-|**Serial Errors**\\ Indicates if errors occurred in serial communication.\\ The parameter is updated for each error encountered. The value persists until a subsequent error or to a writing on the same with the QCL.\\ **0** = no errors,\\ **1** = parity error,\\ **2** = framing error,\\ **3** = overrun error.| |
| |
| === - Stati === | === - States === |
| ^Nome^D^R^A^Condizioni^ Descrizione^ | |
| |st_msgrx|F|0|R||-|**Message received**\\ Stato utilizzato solo in modalitá slave. Indica che un messagio del master ha eseguito una scrittura nell’area scambio dati QCL. Lo stato viene resettato con il comando RECEIVED.| | ^Name^D^R^A^Conditions^Description^ |
| |st_opencom|F|0|R|-|**Open communication port**\\ L'attivazione indica che il device sta impegnando la porta di comunicazione seriale. Per settare questo stato usare il comando OPENCOM, per resettarlo CLOSECOM.| | |st_msgrx|F|0|R|-|**Message received**\\ State used only in slave mode. Indicates that a message from the master has executed a write in the QCL data exchange area. The state is reset with the RECEIVED command.| |
| |wdata|F|0|R|-|**Warning Data**\\ Questo bit segnala che è stato tentato un inserimento di un valore non valido in un parametro.| | |st_opencom|F|0|R|-|**Open communication port**\\ Activation indicates that the device is working with the serial communications port. To set this state use the OPENCOM command, for reset use CLOSECOM.| |
| |wcmd|F|0|R|-|**Warning Command**\\ Questo bit segnala che è non è stato eseguito un comando perchè mancano le condizioni necessarie.| | |wdata|F|0|R|-|**Warning Data**\\ This bit indicates that an attempt was made to insert an invalid value in a parameter.| |
| | |wcmd|F|0|R|-|**Warning Command**\\ This bit indicates that it did not execute a command because they lack the necessary conditions.| |
| |
| === - Comandi === | === - Comandi === |