Differences

This shows you the differences between two versions of the page.

--- en:strumenti:qmoveplus:c1r44:p1r44f-001:mdo_p1r44f-009 [2022/12/23 15:20] – [Table] qem215
+++ en:strumenti:qmoveplus:c1r44:p1r44f-001:mdo_p1r44f-009 [2022/12/23 15:49] (current) – [Belt] qem215
@@ Line 218: / Line 218: @@
 Look in the [[en/strumenti:qmoveplus:c1r44:p1r44f-001:mmf_p1r44f-009|start up manual]] how to best perform the procedures.
-<html><pagebreak /></html>
+The button {{:strumenti:qmoveplus:c1r44:p1r44f-001:offset_button.png?nolink&100|}} open the page "Offset tools":
+{{:strumenti:qmoveplus:c1r44:p1r44f-001:offset_teste.png?nolink&500|}}
+In this page is possible to set a horizontal offset for every single head.\\ The button =0 reset all the offset values \\ The button "progression" associate to every head the value "progression of" + offset of the head before.
 ==== Orthogonal correction====
 Look image [[#Functioning| general view machine]]
@@ Line 423: / Line 428: @@
 If the machine is in **MANUAL** state:\\  press button {{:strumenti:qmoveplus:c1r44:p1r44f-001:pulsante_rulliere.png?nolink&50|}}  to activate O3: ROLLERS RUN, \\ press button{{:en:strumenti:qmoveplus:c1r44:p1r44f-001:belt_page.png?nolink&90|}} to activate O2 "BELT RUN"
 <html><pagebreak /></html>
+===== Enable/Disable Tools =====
+{{:strumenti:qmoveplus:c1r44:p1r44f-001:enable_disable_page_button.png?100&nolink}} -> {{:strumenti:qmoveplus:c1r44:p1r44f-001:enable_head_page.png?nolink&400|}}
+In this page it's possible to enable or disable the tools.\\ Led on (yellow) = tool enabled\\ Led off(grey) = tool disabled
 <html><pagebreak /></html>