P1R31FE30 - 003 : Varianti rispetto a P17.042.1
New setup parameters
Have been moved two existing parameters and included two new parameters in the setup page generic.
| Parameters name | Unit of measure | Default | Range | Description |
|---|---|---|---|---|
| DxRot distance | mm | 0.0 | -9999.9 ÷ 99999.9 | The X distance between the rotation axis C and the axis of rotation of the spindle when the axis C is located at 0 ° and the axis A is located at 90°. |
| DyRot distance | mm | 20.0 | -9999.9 ÷ 99999.9 | The Y distance between the rotation axis C and the vertical axis of the blade when the axis C is located at 0 ° and the axis A is located at 90° (see the next image). |
| DzRot distance | mm | 171.0 | -9999.9 ÷ 99999.9 | The Z distance between the tilt axis A and the axis of rotation of the spindle (see the next image). |
| DyAC distance | mm | 119.0 | -9999.9 ÷ 99999.9 | The distance between the C axis and the A axis (see the next image). |
There is a new setup page for the A axis:
| Parameters name | Unit of measure | Default | Range | Description |
|---|---|---|---|---|
| Resolution | - | 1/1 | - | The resolution parameters to convert pulse to degrees: measure in °/10 over pulse. |
| Tolerance | ° | 0 | 0.0 ÷ 99999.9 | The tolerance to check if the tilt position of A is to the right displacement. |
| Min A angle | rad | 0 | 0.0 ÷ 9.99999 | It is the minimun angle for axis A. If the A position is less than this angle, the cut will not be done. |
New features in manual
There is a new feature allow on each manual page.
When you touch on the next button, it will toggle on one of the next picture. The meaning is the next:
 | By the Z joystick activation, the machine move only the Z axis. So it will be a vertical displacement. |
 | By the Z joystick activation, the machine move the three XYZ axis in according of the A and C positions. So it will be a cut direction displacement. |
New work "Rectangle"
There is a new work allow from the execution menu page. It is “Rectangle”:
There are the next work parameters:
| Parameters name/picture | Unit of measure | Range | Description |
|---|---|---|---|
 | mm | 0 ÷ 99999.9 | W and H are the rectangle dimensions. These are the dimensions on the upper surface of the slab. The software processes the cut position in according to the saw thickness and tilting. |
 | - | - | For each edge of the rectangle you have to set the angle orientation. Touch on the icon, press the  button to select the right icon and then press  . As you can see from the icons, the tilting can be towards the inside or towards the outside of the rectangle. |
 |
|||
| A | ° | 10.0 ÷ 90.0 | The operator has to insert the tilting angle for each edges, even for vertical cut (90°). |
 | - | - | The operator can enable or disable each edges of the rectangle. He has to just touch the |
 |
|||
 | mm | 0 ÷ 99999.9 | The operator has to insert the slab thickness. |
 | mm | -99999.9 ÷ 99999.9 | It is possible to apply a correction of the start quote of the cut. |
 | mm | -99999.9 ÷ 99999.9 | It is possible to apply a correction of the end quote of the cut. |