12-Head Standard Polishing Machine: Wiring connections
![]() |
|||
Document | mce_p1p51fc20-008 | ||
---|---|---|---|
Description | Wiring connections for 12-Head Standard Polishing Machine | ||
Drawn up | Davide Mocellin | ||
Approved | Gabriele Bazzi | ||
Link | http://www.qem.eu/doku/doku.php/en/applicazioni/marmo/levigatrice_di_lastre/standard_12_heads/mce_standard_12_heads | ||
Language | English | ||
Document Release | Description | Notes | Date |
01 | New manual | 20/11/2014 |
All rights reserved on this manual. No part of this document can be copied or reproduced in any form without prior written authorisation. QEM does not insure or guarantee its contents and explicitly declines all liability related to the guarantee of its suitability for any purpose. The information in this document can be changed without notice. QEM shall not be held liable for any error or omission in this document. QEM® is a registered trademark.Microsoft® and MS-DOS® are registered trademarks and Windows® is a trademark of Microsoft Corporation.
1. Hardware
1.1 Operator Panel
J1-P51-FC20/TP03 | |
---|---|
![]() |
|
![]() |
|
![]() | MIMJ1P51Fx:Installation and Maintenance Manual |
1.2 Remote modules inputs/outputs
2. I/O Resources
2.1 Digital Inputs
-
NO = Normally Opened
-
NC = Normally Closed
-
PR = Programmable
-
I = Impulsive
-
C = Continuous
2.2 Digital Outputs
-
I = Impulsive
-
C = Continuous
-
PR = Programmable
2.3 Two-way Encoder Count Inputs